Skip to main content

Crash Query - Line Tool Overview

Select a stretch of road and filter your query to it

Written by Lauren Miller

The Line Tool in Crash Query lets you select a roadway section by selecting the road on the map and defining the section's beginning and end boundaries.

Once defined, the selected roadway section is added as a query filter.
​

Use the Line Tool


1. Zoom to the desired section of roadway on the crash map.
​

Crash Query map zoomed to a section of roadway

(The map zoomed to the roadway)
​

2. Click the Line Tool icon in the Map Toolbar.
​

Line Tool selected in the Map Toolbar with roadways shown on the map

(The Line Tool selected, with available roadways on the map)
​

With the Line Tool selected, all available roadways display on the map. The map displays more roadways as you zoom in. If you cannot see the roadway you want to select, keep zooming in until the roadway line appears.

The roadways displayed on the map represent each agency's Linear Referencing System (LRS). The map displays only roadways contained within the LRS.

3. Once you identify the roadway you want to select, click the roadway to define the first boundary of your filter area (either the beginning or ending boundary).

ℹ️ Note: If auto-zoom is on, the map may zoom in or out to show the entire selected roadway.

If it is difficult to click the beginning/ending milepoint because crash locations are displayed on the map, you can hide them by clicking the Hide crashes icon (the eye icon) in the crash count at the top of the map.
​

Hide crashes eye icon in the crash count at the top of the Crash Query map

(Hide Crashes in Crash Query)
​

4. With the first boundary set, click to place the second boundary on the roadway.
​

Second boundary placed on the selected roadway

(The second boundary placed on the roadway)
​

5. The route filter, showing the precise beginning and ending milepoints of the selected roadway section, appears in the Filter Bar.
​

Route filter with beginning and ending milepoints in the Filter Bar

(The route filter in the Filter Bar)
​

Edit Line Tool Selections

To modify the selection boundaries, edit the values in the Filter Bar or edit the boundary line directly on the map.

To edit the values in the Filter Bar:

Click the beginning or ending milepoint value and type in the new value.

To edit the boundary line on the map:

  1. Click the boundary line to enter edit mode.

  2. Click the point you want to move.

  3. Click the new location on the selected line to save the updated point.

Clicking the boundary line, a point, and a new location to edit a Line Tool selection

(Editing a Line Tool selection on the map)
​

ℹ️ Note: You can use the Line Tool to filter more than one roadway section in the same query. Repeat the steps above for each additional section.

Two roadway sections selected with the Line Tool in the same query

(Two roadway sections selected in the same query)

Did this answer your question?